Fiat 500 Replacement Key Fob
If your 500 remote key fob has stopped working, it may be time to replace the battery. If you replace the battery, but it doesn't work, the problem may be somewhere else.
At United Locksmith, we specialize in making new keys for classic automobiles. We have all of the tools and components needed to perform this service.
Dead Coin Battery
The most frequent reason that your Fiat 500 key fob will not lock or unlock the doors is due to a dead battery. The battery inside the key fob is likely to drain quickly when you don't utilize frequently enough. If your remote has started to show signs like a loss of range or has stopped functioning or not responding, then the battery could be dead.
Metal clips hold the battery in within the key fob. If the clips are not secure, they could cause problems with contact that can prevent your remote to receive power. Use a flathead screwdriver to remove the retaining clip and remove the old battery. Be sure to choose an alternative battery that has the same type of voltage, dimensions, and specification as the original battery.
The key fob may also be damaged or corroded through exposure to water. Even a short bath in soapy water can damage the electronic chip inside. It's best to keep your key fob in a dry location.
Water Damage
Water damage may be the cause of your key fob's not functioning properly. Key fobs have rubber seals that prevent them from being damaged by light rain or a splash of water. However, it is very important to keep your keys away from the pool, ocean, and the washing machine!
The key fob has an electronic chip that sends a message to the immobilizer system of your car. This is what allows your 500 to start or lock, however if the chip gets wet, it can no longer work.
You can clean the inside of your key fob's electronics using isopropyl alcohol or an electronic cleaner to determine if they are still good. It is best to replace a key fob in the event that it has been submerged into salt water rather than try to repair it yourself.
A replacement fob may cost you a few dollars however it's much cheaper than having to have your Fiat 500 towed to a dealer and fixed there! You can also fix it yourself by following some simple steps. Be fiat 500 new key to have the correct type of battery before attempting to open your keyfob. There are step-by-step directions for any car keyfob on the internet.
Faulty Chip
The chip in the key fob communicates directly with the immobiliser of your car to ensure that your vehicle will only start when the correct keys are inserted. If the chip is damaged, or corrupted the car will not start no matter what you do.
Damage to the water or a dead cell battery are the most common causes of a faulty chip. It is best to hand over the repair to a professional locksmith who can replace the chip in a short time and at a reasonable cost.
If your key fob will not work after exposure to water that is clean from the tap or rain take it off the battery. Clean the electronic component with a towel. If the key fob will not function, there is the possibility that it's damaged components and requires to be replaced.
Many people will seek out their dealer when in need of an entirely new Fiat key fob, but it can be a costly alternative. United Locksmith is the best choice if you need your Fiat key fob replaced at a reasonable price. We have the tools and expertise necessary to repair your Fiat key fob in a timely and professional manner.
Faulty Receiver Module
Fiat key fobs send signals of up 50 feet to the vehicle, which will unlock and lock the doors (and start the vehicle in case of automatic transmissions). However there are some things that can cause the fob to stop functioning. This includes a dead coin-battery, water damage, worn out buttons or a receiver issue signal interference or a malfunctioning chip.
If the fob was located in the pocket of someone who has suffered extreme trauma (such as being dropped on the floor or washed in the washer) the fob may not be in a position to connect with the Body Control Module (BCM) of the vehicle. This is because the BCM is a secure system that can only accept signals from a genuine original key and not another.
If this is the case, then you will require replacing your fob. A professional locksmith can take care of every aspect of the key replacement procedure, including programming a new one for your 500. They can even offer an identical fob that functions just like the original (and costs only a fraction of the cost).